EIBENSTOCK EBS 120.1 Notice Originale page 18

Changing the brush rim
If the length of the brushes is – due to wear - smaller than 5 mm (extreme
formation of dust during grinding), the brush rim has to be replaced
completely. Pull out the worn brush rim and replace it by a new one.
Instruction for Use
Switch the machine on and put it carefully on the surface you want to work
on. Hold the tool with both hands and work with circular or linear
movements. For best working results: Don't put too much pressure on the
surface you want to work on.
Attention!
All other grinding works have to be done with the complete dust
guard.
Care and Maintenance
Before the beginning of the maintenance- or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an electric specialist.
Due to its design, the power tool needs a minimum of care and
maintenance. The following works have to be carried out or rather the
component parts have to be inspected:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw Material Recycling Instead of Waste Disposal
To avoid damages on transportation, the power tool has to be delivered in
a sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
For grinding works right into edges of the wall one
segment of the dust guard can be opened by means of
the chucking device. This allows grinding on surfaces
which are usually hard to reach.
In this case, an increased amount of dust is possible.
18