EIBENSTOCK EBS 120.1 Notice Originale page 17

Changing the Diamond Grinding Wheel
Attention!
The grinding wheel might heat up enormously during operation. You
could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
Dust Extraction
Dust which occurs during your work is hazardous to health. That is why the
EBS 120.1 must be used with a vacuum cleaner, and a dust mask has to
be worn. The suitable Wet/Dry Vacuum Cleaner (dust category M) is
available as accessory. It can directly be attached to the connection on the
dust hood.
Actuate the spindle stop and keep it pressed.
Use the face spanner to unscrew the driving nut.
Then remove the mounted grinding wheel
respectively mount the new one.
The assembly works the other way round!
Pay attention that the collar of the clamping nut faces
away from the machine, as shown in the figure.
In order to check whether the spindle stop is
released before you switch on the tool, turn the
spindle slightly.
Let the machine run for a short period of time and in
a safe position. If the machine does not run easily,
stop working immediately.
Use only original accessory!
17