Philips AC4084 Mode D'emploi page 21

3
To remove the pre-filter, press the two
clips down and pull the filter towards you.
1
2
4
Remove the Multi-care filter from the pre-
filter.
5
Wash the pre-filter under a running tap. If
the pre-filter is very dirty, use a soft brush
to brush away the dust.
6
Air dry the pre-filter.
7
Slide the Multi-care filter (if available) into
the pre-filter.
8
Put the pre-filter back into the appliance.
Attach all hooks properly to the appliance.
2
1
9
To reattach the front panel, insert the top
hooks into the top of the air appliance first
(1). Then, push the panel against the body
of the appliance (2).
2
Note
•
Alternatively, you can clean the pre-filter by
removing the dust with a vacuum cleaner.
•
Make sure that the pre-filter is completely dry.
If it is still wet, bacteria may multiply in it and
shorten the lifetime of the pre-filter.
•
Make sure that the side with two clips is pointing
towards you, and that all hooks of the pre-filter
are properly attached to the appliance.
1
EN 21