Attaching The Plasma Display - Pioneer PDK-1015 Mode D'emploi

Attaching the Plasma Display

The weight of a Plasma Display is about 50 kg
(110 lbs), they have no depth, and are unstable.
Therefore, at least two people must assemble and
Caution
install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and tighten them
firmly.
Attachment Method
1
Attaching the Plasma Display to the stand.
Fit the stand's support columns to the bottom of the
Plasma Display as indicated by the arrows, then slowly
insert them vertically. Be extremely careful not to insert the
support columns of the stand into any part of the Plasma
Display other than the stand insertion slots. Note that doing
so might damage the Plasma Display panel or its ports or
result in the warping of the stand.
4
En
2
Line up the column
supports with the
bottom of the Plasma
Display as indicated
in the accompanying
diagram.
Securing the Plasma Display with
Installation bolts.
Attach the Plasma Display at the points indicated below
using the phillips screwdriver.
Installation bolts
(M6 x 20 mm: black)