GE GDF Série Manuel D'utilisation page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Possible Causes
Cloudiness on
Combination of soft water and
glassware
too much detergent
Low performing phosphate
free detergent
Water temperature entering the
dishwasher exceeds 150°F (66°C)
Suds in the tub
Correct detergent
wasn't used
Rinse agent was spilled
Detergent left in
Dishes are blocking the
dispenser cups
detergent cup
Black or gray
Aluminum utensils have
marks on dishes
rubbed against dishes
Dishes don't dry
Low inlet water temperature
Rinse agent dispenser is empty
Control panel responded Door may not be completely
to inputs but dishwasher closed
never filled with water
Water valve may be turned off
Stained tub interior
Some tomato-based foods can
cause reddish stains
Tea or coffee stains
An overall yellow or brown film can
be caused by iron deposits in water
hard water minerals
Dishwasher won't run Fuse is blown or circuit breaker
is tripped
Power is turned off
Control panel is locked
What To Do
use less detergent if you have soft water. Wash glassware in the shortest
cycle that will get it clean.
A white film on glassware, dishware and the interior in this
Troubleshooting section.
Automatic Dishwashing Detergents have been approved for use in all
GE dishwashers.
Pump out water by pressing Start and close the door. Wait 30 seconds.
Open the door, press and hold Start for 3 seconds, and close the door.
Repeat if necessary.
the detergent cup. See the Loading the dishwasher racks section.
Heated Dry.
Wash Temp Boost option.
Steam cycle (on some models) after adding the dish to the load
can decrease the level of staining.
3 cups warm water. NOTE: Do not use bleach on stainless steel
tub or inner door.
CAUTION!
Before cleaning interior, wait at least 20 minutes after a cycle for the
heating elements to cool down. Failure to do so can result in burns.
this problem. Contact a water softener company.
Cascade
mineral deposits from forming.
(Part number: WD35X151) can be ordered through GE Parts. See back
cover for ordering information.
the circuit.
wall switch, often located next to the disposer switch. Make sure it is on.
Wash Temp Sani (Sanitize) or Heavy.
Rinse Aid™ to help prevent hard water
®
Getting started section.
GEAppliances.com
Cascade
®
13

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Gdf510Gdf520Gdt530Gdf540Gdt550

Table des Matières