General Warnings
To ensure the safe installation, adjustment, and operation of the Bath Bench, these instructions MUST be followed.
FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN SERIOUS INJURY TO THE USER OR DAMAGE TO THE PRODUCT.
If you are unable to understand these warnings, cautions, and instructions, contact a healthcare professional or dealer before
attempting to use this equipment.
Warnings:
!
Prior to each use check to assure that all screws, joints and fittings on the bath bench are tight.
!
DO NOT place bath bench on uneven surfaces.
!
DO NOT use if wobbly, unstable or not level.
!
DO NOT exceed user weight capacity of 350 lbs (159 kgs).
!
DO NOT stand on the bath bench.
!
DO NOT twist or turn while seating on the bath bench, this may cause damage to the frame.
!
DO NOT use the bath bench for anything but its intended purpose.
√
When using the back rest, ensure the bench remains balanced. Excessive twisting or turning
while seated on the bench may cause a loss of balance and damage to the product. (Only pertains to MDS89745RA)
√
Check rubber tips for rips, cracks or wear. If these conditions exist,
DO NOT use the bath bench and replace the tips immediately.
√
Check the bench for cracks or ruptures in the plastic. If you have concerns, contact the
manufacturer at 1-800-633-5463.
√
Check that all push buttons are fully protruded from the main frame through the leg extensions
and are properly engaged.
√
Ensure all four legs are adjusted evenly and are free of any obstructions prior to use.
√
When transferring in and out of unit, evenly distribute weight between the arm supports.
Parts Listing
Ensure that you have all of the necessary components before assembling
your bath bench.
• 1 (each) Bench (Imprinted with an A and B)
• 2 (each) Aluminum Main Frames (imprinted A and B)
• 4 (each) Aluminum Extension Legs
• 2 (each) Padded Arm Rests
• 1 (each) Backrest (Only pertains to MDS89745RA)
• 9 (each) Hand Screws for MDS89745RA
• 5 (each) Hand Screws for MDS89740RWA
• 2 (each) Aluminum Backrest Frames (only MDS89745RA)
• 1 (each) Curved Washer
• 2 Reinforcement Bars (only MDS89740RWA)
2
MDS89745RA (PIC-00303)
Rev: 04/30/2020