Clock Settings; Timer Function Settings - cec GO'pac Manuel D'instructions

4. USER INTERFACE (continued)

4.2 Clock settings

1) Make sure that the pump is off.
2) Press once on
3) Set the hours with
4) Press on
CLOCK
5) Press to confirm.
CLOCK

4.3 Timer function settings

Setting this function is necessary if you would like to run the heat pump for
a shorter period than what is defined by the filtration clock. Therefore, you
can program a deferred start and an anticipated stop or simply stop a certain
timeframe from running (at night, for example). First make sure that the clock
has been set properly.
Start Program (Timer ON) / Start
1) Press on
TIME
ON
TIME
2) Press
, the hours flash. Set the hours with
OFF
TIME
ON
TIME
3) Press
to set the minutes with
OFF
TIME
ON
TIME
4) Press to validate.
OFF
CLOCK
A green light indicates that the Timer ON has been activated.
Note : The setting is automatically saved after 25 s without action.
, the time display flashes.
CLOCK
or
again to set the minutes using
, the time display flashes.
buttons.
buttons.
or buttons.
buttons.
13