Hilti NURON SJT 6-22 Mode D'emploi Original page 16

5.7 Installing anti-splinter insert
▶ Press the anti-splinter insert into the base plate from below.
The anti-splinter insert can be used only with the saw blades for which it is designed.
The anti-splinter insert can be used only when the base plate is in the normal position (0° cutting
angle). → page 10
5.8 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Using a dust extractor
The dust extractor reduces dust emissions, increases working safety by providing better visibility of
the cutting line and reduces exposure to dust and wood chips at the workplace.
1. Fit the guard. → page 9
2. Always use a dust extractor when working over a lengthy period with wood or materials that can cause
high dust concentrations.
6.2 Setting the cutting angle
1. Remove the suction adapter. → page 11
2. Slacken the screw on the base plate.
3. Adjust the base plate to the desired cutting angle (from 0° to 45° in both directions).
▶ At the 0° cutting angle, the base plate is held in a rotation-locked position. To set a different cutting
angle, you must first pull the base plate to the rear.
▶ When you return the base plate to the 0° cutting angle, push the base plate forward again to re-engage
it in this rotation-locked position.
4. Retighten the screw.
▶ The base plate is clamped securely.
6.3 Switching on
A safety interlock ensures that the product does not start when the product is switched on first and
the battery inserted afterward.
Slide the on/off switch back and then forward again.
10 English
5
6
2264219
*2264219*