HK Audio LUCAS NANO 605 FX Mode D'emploi page 13

6 Technical Specifi cations
LUCAS NANO 605 FX System
Total power output*
Frequency response +/- 3 dB
Active protective circuits
Special Features
Enclosure
Optional accessories
Weight
LUCAS NANO 605 FX Subwoofer
Max SPL peak**
Frequency response +/- 3 dB 43 Hz - 190 Hz
Inputs
Outputs
Bass woofer
Nominal impedance
Pole mount
Dimensions (WxHxD)
Weight
LUCAS NANO 600 Series Satellite
Max SPL peak**
Frequency response +/- 3 dB
Woofer
HF driver
Horn directivity
Nominal impedance
Inputs
Pole Mount Adapter
Dimensions (WxHxD)
Weight
* measured according to EIA ** @10% THD, half space
460 W (300 W + 2 x 80 W) Class D
43 Hz – 20 kHz
MultiBand Limiter, Subsonic Filter,
Thermo Protection, Overload Protection
5-Channel Mixer, 2-Band EQ for Channels
1-3, 7 Reverb Eff ects, Bluetooth Audio
Streaming
Coated polypropylene
S-Connect Pole LN (signal-routing
speaker pole), Mono Stand Add-on 600
Series, Stereo Stand Add-on 600 Series,
Roller Bag 600 Series (padded trolley),
Desk/Wall Mount, Link Cable, Drum Rack
Adapter
16.3 kg / 35.9 lbs.
123 dB
3x Combination 1/4" (6.3 mm)/XLR Ports,
2x 1/4" (6.3 mm) Jacks/Stereo Mini-Jack,
Bluetooth In, Link In (for Twin Stereo
Mode)
Speaker Out, Easy Click, Mix/Thru Out,
Footswitch/Aux Send Out, Link Out (for
Twin Stereo Mode)
10"
8 ohms
M33 for the (signal-routing) S-Connect
Pole LN, a speaker pole adapter sleeve
(M33 to M20) is included
35 x 49 x 47 cm
13.9 kg / 30.6 lbs.
124 dB (Single Satellite)
130 dB (Satellite Array)
190 Hz – 20 kHz
4,5"
1" HK Audio Multicell Transformer
90° x +10/-45° (Single Satellite)
90° x 30° (Satellite Array)
8 ohms (Single Satellite)
4 ohms (Satellite Array)
Speaker In, Easy-Click
3/8" thread
14.5 x 14.5 x 13.5 cm
1.2kg / 2.6 lbs.
General Technical Specifi cations
Peak current 0.7 A / 220-240V AC • 1.5 A / 100-120V AC
Inrush current 46 A at 120 V and 230 V
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Stamer Musikanlagen
GmbH is under license.
For USA:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter meets both portable and mobile limits as demonstrated in the RF Exposure Analysis. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures.
For Canada:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
LUCAS NANO 605 FX 1.0
13