Safety Devices; Operation; Prior To Initial Operation; Mains Connection - Metabo Power 380 T Instructions D'utilisation Originales

ENGLISH
3.3

Safety devices

Safety valve
The spring-loaded safety valve (14) is
incorporated into the pressure switch.
The safety valve opens if the max. per-
missible pressure is exceeded.

4. Operation

4.1

Prior to initial operation

Oil dip stick installation
1. Remove the plug (15) from the
crank case.
16
15
2. Fit the oil dip stick (16) supplied
instead of the plug.
The plug prevents oil from leaking from
the crankcase during shipping. Keep the
plug for later use.
4.2

Mains connection

B
Danger! High voltage
Operate device in dry environ-
ment only.
Operate device only on a power
source complying with the following
requirements:
− outlets properly installed, earthed
and tested;
− fuse protection in accordance
with the Technical Specifications.
Position power cable so it does not
interfere with the work and is not
damaged.
Always check to see that the device is
switched OFF before plugging in.
10
Protect power
aggressive liquids and sharp edges.
Use only extension cables with suffi-
cient lead cross section (see "Techni-
cal Specifications").
Do not stop the compressor by
unplugging, but switch OFF using the
switch.
Unplug after use.
4.3

Generating compressed air

14
1. Start device (17) and wait until the
max. tank pressure is reached
(compressor shuts off).
The tank pressure is indicated by
the tank pressure gauge (18).
20 19
21
2. Set pressure regulator (19) to
required working pressure. The cur-
rent working pressure is indicated by
the regulated pressure gauge (20).
A
Caution!
The regulated pressure may
not be set higher than the max. work-
ing pressure of the connected air
tools!
3. Connect air hose to compressor
(21).
4. Connect air tool.
You are now ready to work with the
air tool.
5. Switch the compressor OFF, if you
do not continue working immediately
afterwards. Unplug after switching
OFF.

5. Care and Maintenance

A
Danger!
Prior to all servicing:
− Switch Off.
− Unplug.
− Wait until the device has come to
a complete stop.
− Ensure the device and all air tools
and accessories connected to it
are relieved from pressure.
cable from heat,
17
18
− Let the device and all air tools
and accessories used cool off.
After all servicing:
− Check to see that all safety
devices are operational.
− Make sure that no tools or other
parts remain on or in the device.
Repair and maintenance work other
than described in this section must
only be carried out by qualified spe-
cialists.
5.1

Periodic maintenance

Prior to each use
•
Check air hoses
replace if necessary.
•
Check all screwed connections for
tightness, tighten if necessary.
•
Check power supply cable for dam-
age, if necessary have replaced by
a qualified electrician.
Every 50 operating hours
•
Check air filter element (22) of com-
pressor pump, clean if necessary.
22
•
Check oil level of compressor pump,
top up if necessary (23).
23
•
Drain the condensate from the pres-
sure vessel into a container (24).
for damage,