Before Use; How To Replace The Turntable Stylus(Needle) - Bigben Interactive TD101 Mode D'emploi

Before Use

1. Choose unit installation location carefully. Avoid placing it in direct sunlight or close to a source
of heat. Also avoid locations subject to vibrations and excessive dust, cold or moisture. Keep away
from sources that hum, such as transformers or motors.
2. Do not open the cabinet as this might result in damage to the circuitry or electrical shock, if a
foreign object should get into the set, contact your dealer.
3. Be sure not to handle record with dirty fingers. Never play a record that has a crack on the
surface.
4. When removing the power plug from the wall outlet, always pull directly on the plug, never
pull the cord.
5. To protect the stylus, don't forget to put on the white protective needle cover after use.
6. Do not attempt to clean the unit with chemical solvents as this might damage the finish.
Use a clean, dry cloth.
7. In order to shut off the power to this product completely, unplug the power cord from the wall
outlet. Be sure to unplug the unit if you do not intend to use it for an extended period of time,
such as a vacation.
8. Keep this manual in a safe place for future reference.
How to Replace the Turntable Stylus (Needle)
Removing old stylus
1. Set a screwdriver at the tip of the stylus and push
down in the direction "A".
2. Remove the stylus by pulling it forward and down.
Installing a new stylus
1. Hold the tip of the stylus and insert the other edge
by pressing in the direction "B".
2. Push up in the direction "C" until it locks at the tip.
18