EN
If the kettle has accidentally been operated without any water in it, it switches
itself off automatically. Allow it to cool down before using it again.
1. Wind up or unwind the mains connecting cable on the bottom of the base station (3)
to the length you want and then place it in the slot which is provided for it on the edge
of the base station.
2. Insert the mains plug into a properly installed socket that is easily accessible.
3. Place the base station on a dry, even, fi rm, water and heat-resistant surface. Do not
place the device below kitchen wall units or similar cupboards. The rising steam could
cause damage to them!
4. Pull the lid's (8) latch towards the handle (2) und simultaneously open the lid.
5. Fill the kettle (5) with at least 0.5 litres (MIN marking) and max. 1.7 litres (MAX mark-
ing) of water. Insuffi cient water will cause the device to switch off prematurely. If the
MAX marking (6) is exceeded, water could splash out during the boiling process.
6. Pull the latch towards the handle and close the lid.
7. Place the kettle on the base station.
8. Set the On / Off switch (1) to position I (ON). The device will turn on and the LED
lighting (4) is lit constantly blue. You can interrupt the boiling process at any time by
setting the On / Off switch to position 0 (OFF).
9. The device automatically deactivates once the water has boiled. The On / Off switch
sets automatically to position 0 (OFF) and the LED lighting switches off.
10. Take the kettle off the base station and carefully pour the water into a vessel. Keep
the lid closed when pouring out the water.
Cleaning and Care
PLEASE NOTE!
■
CAUTION – Danger of burns! The surface of the kettle also becomes hot from the
heated contents. Allow it to cool down before cleaning it.
■
Regularly descale the device.
■
The device is not dishwasher-safe.
■
Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These can damage the surface.
1. Completely empty the kettle (5).
2. Rinse out the kettle with a little mild detergent and clear water. Make sure that no
water gets into the contacts on the bottom of the kettle! Do not immerse the
kettle in water! This could cause a short circuit.
3. Dry the kettle thoroughly.
4. If necessary, wipe down the base station (3) with a dry cloth.
5. Keep the device ready to operate. Remove limescale deposits with a descaling agent.
Follow the instructions on how to use the descaling agent.
6. The kettle can be stored on the base station when it is not being used. In this case,
pull the mains plug from the plug socket as the kettle is in stand-by mode while it is
connected to the mains power.
16