Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

User's guide
c. Remove the valve cap from your inflatable object if there is one.
d. Insert the other end of the valve stem adapter into inflatable's air valve opening
as far as possible.
6. Set the Tire Inflator Switch on to the "I" position to start inflation. Monitor the pressure
gauge while inflating the tire.
7. When recommended tire pressure has been reached, turn off the tire inflator.
8. Disconnect the hose and replace valve cap.
9. Return the hose back to its compartment for storage.
10. Recharge the unit as soon as it is convenient.

POWER INVERTER

The Power Inverter can run most AC appliances or a combination of appliances up to 200 watts.
Operating time is dependant on the AC load (required wattage) and the current charge/condition
of the internal battery. Reduced AC loads and/or having a full charge on the internal battery will
result in longer operating time. Ordinary overloads will cause the inverter to automatically shut
down. Reduce the load and restart the inverter.
There is a user-replaceable automotive-type fuse protecting the inverter from an unlikely excessive
power draw or short circuit. REPLACE ONLY WITH THE SAME TYPE AND RATING FUSE. To replace
the fuse, simply pull it out with a pair of needle nose pliers and insert the new fuse.
Caution
Some rechargeable devices are equipped with a separate AC charger. These devices are
likely to operate properly with the inverter in this unit. Rechargeable devices that have built-in
chargers (see your device's user manual) may not operate properly with this unit because the
inverter is modified sine wave.
Some motorized devices may operate at excessively elevated temperature when used with this
inverter. During first use with this inverter, check for excessive motor temperature. Abnormally
elevated temperature of the device is an indication that they should not be used together.
Operation
1. Check the required current draw of the appliance/device to be powered and make sure it does
not exceed the Power Inverter's maximum wattage.
2. Prior to plugging in your device, turn your power tool or appliance off. Mobile devices are
fine to keep on, but operating them during the charging process will prolong charging time.
3. Open the AC outlet dust cover.
4. Connect the electrical plug of your device/appliance to either of the two AC outlets.
5. Set the Inverter Switch to the "|" position.
6. Observe the Inverter Power Indicator. If the LED remains green, proceed to plugging in and
turning on the second device/appliance.
• If the power indicator remains green, then both devices/appliances are operating properly.
• If the power indicator is no longer lit, reduce the AC load. If the inverter still does not
operate after load is reduced, refer to the troubleshooting table at the end of this User's
Guide.After use, remove the device/appliance plug(s), close the dust cover(s), and turn the
Inverter Switch off.
7. Recharge the unit as soon as it is convenient.
13

Publicité

Table des Matières
loading

Table des Matières