stayer DM1450 Instructions D'emploi page 11

Preselection of rotation
With the rotational adjustments can be preselected power
progressively rotation. The rotation required depends on
the material to be it is advisable to pre- mix and make
acheck through a practical control.
Selector de marchas
In models with two mechanical speed 1 speed , high tor-
que for thick mixtures and speed 2 , medium pair , for
lighter blends that enable faster work is used. With the
machine off using the selector 1 to change the fly.
It is possible to change fear when the machine is running.
However , this should not be done wen the machine is at
full load.
Constant-Electronics
The constant electronics keeps the speed virtually cons-
tant during idling and under a load. This guarantees thar
materials are mixed uniformly.
Electronic overload protection
An electronic overload devide protects the motor agains
damage when the tool is under an extreme load. In this
case, the motor stops and only starts up again when the
feed is reduced or the load removed (only model 1600)
Temperature-dependent overload protection
To prevent the motor from overheating under an extreme
continuous load, the safety electronics switches the motor
off when it reaches a critical temperature.
After a coolong-down time of around 3 – 5 min., the m
chine is ready for operation at full load. If the tool is warm
from operation, the temperature-dependent overload pro-
tection will respond earlier.
Operating Instructions
The choice of stirrer paddle depends on the material to
be stirred. For materials with low viscosity, e. g., disper-
sion paint, varnish, adhesions, casting compound, cement
grout, etc., use a stirrer paddle with left-hand spiral.
For materials with high viscosity, e. g., ready-mixed plas-
ter, concrete, cement, screed, filler, epoxy resin, etc., use
a stirrer paddle with right-hand spiral. While mixing, move
the power tool in an up and down motion. Clean the stirror
paddle after use.
Maintenance and Service
Maintenance and Cleaning
- Before any work on the machine itself, pull the
mains plug.
ENGLISH
11
- For safe and proper working, always keep the ma-
chine and ventilation slots clean.
If the machine should fail despite the care taken in m
nufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Stayer
power tools.
WARNING! Important instructions for connecting a
new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Do not connect the blue or brown wire to the earth termi-
nal of the plug.
Important: If for any reason the moulded plug is remo-
ved from the cable of this power tool, it must be disposed
of safely.
Disposal
The machine, accessories and packaging should be sor-
ted for environmental-friendly recycling.
Only for EC countries:
¡Do not dispose of power tools into house-
hold waste! According the European Guideli-
ne 2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation
into nationa l right, power tools that are no
longer usable must be collected separately
and disposed of in an environmentally correct manner
Declaración de conformidad
We declare under our sole responsibility that this product
is in conformity with the following standards or standardi-
zation documents:
EN 60745-1, EN 60745-2-1, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3 according to the provisions
of the directives 2006/42/EC, 2014/30/EU.
Ramiro de la Fuente
Director Manager
11
05 de january de 2017