Alto Professional AEQ215 Guide D'utilisation page 7

Connecting the AEQ215 from Mixer auxiliary outputs ("In-Line")
Adding EQ to stage monitors is helpful in controlling feedback and shaping the perfect monitor mix. In this
configuration, EQ will be applied to the monitor path only.
Note: We recommended using pre-fader auxiliary sends for controlling stage monitor levels.
1. Connect Mixer auxiliary Output 1 to the XLR Balanced Input or 1/4" TRS on AEQ215 Channel 1.
2. Connect AEQ215 Channel 1 output to amplifier input or powered loudspeaker input. The EQ is now "in-line"
between the mixer Auxiliary output and loudspeaker amplifier.
3. For the connection between the mixer's auxiliary output 2 and Channel 2 input on AEQ215 follow the same
pattern as seen in steps 1-2.
From mixer auxiliary
output
Inserting the AEQ215 on a Mixer Channel Insert
Stereo Insert cable (1 TRS 1/4" Male to 2 Mono 1/4" Male) will be required for this configuration. AEQ215 channel 1 is
listed for example only. Both channels can be used in this configuration. Use only one AEQ215 channel per mixer
channel insert.
1. Connect the TRS end of the Insert cable to the mixer's Channel Insert.
2. Connect the Tip end of the Insert cable to the balanced 1/4" Channel 1 input of AEQ215.
3. Connect the Ring end of the Insert cable to the balanced 1/4" Channel 1 output of AEQ215.
Channel 1 OUT
Channel 1 IN
To power amplifier
Channel Insert
CH 1
OUT
Channel 2 OUT
input or powered
speakers
CH 1
IN
7
Channel 2 IN
From mixer auxiliary
output