Publicité
Les langues disponibles
Les langues disponibles
1
2
FRONT PANEL
1.
EQ Bands – Use these sliders to boost or cut the level of each audio frequency band.
in the center position, the equalizer outputs a flat frequency response.
2.
Input Level Meter – Displays the level of the incoming signal.
attenuation). If the clip LED lights continuously, turn down this control.
3.
SIG CLIP – Flashes red when the input or output signal gets within
the input or output signal to avoid distortion.
4.
Range –
Selects which of the two boost/cut ranges the EQ band sliders will use, either ±6 dB or ±15 dB.
WARNING: Adjusting this switch generates a loud transient. Before changing the setting of the switch, reduce
the audio level of your power amplifier.
5.
Hi Pass – Reduces the low frequencies from the signal.
6.
Low Pass – Reduces the high frequencies from the signal.
7.
EQ On – Select to bypass the EQ and hear the unprocessed signal.
REAR PANEL
1
2
1.
Power Connector –
2.
Power Switch – Use this switch to power AEQ215 on/off.
3.
Ground Lift – Disconnects the signal ground from the chassis ground. If the equalizer is causing any
buzz in your system due to a ground loop, move this switch to the "lift" position.
4.
RCA Outputs – Connect these outputs to a mixer's Aux Return or powered speakers.
5.
1/4" and XLR Outputs – Connect these outputs to a mixer's Aux Return or powered speakers.
6.
RCA Inputs
– Connect these inputs to a mixer's Main output or Aux Send.
7.
1/4" and XLR Inputs – Connect these inputs to a mixer's Main output or Aux Send.
4
3
1
2
4
3
Connect the included power cable here.
1
2
7
5
6
3
6
5
4
7
The "0 dB" position is unity gain (no boost or
7
5
6
3
4 5
6 7
4
5
4
6
When all the sliders are
5 dB of
clipping. If this occurs, turn down
5
4
6
1
7
7
hum or
3
4 5
2
6 7
Publicité
