Installation; Plates; Dimensions; Location - Zanotti SP1 Mode D'emploi Et D'entretien

6. INSTALLATION

6.1 P lates
The unit is supplied with warning and attention plates as listed in the relevant table.

6.2 Dimensions

SP1 (SPO 121-123)
SP2 (SPO 221)
SP3 (SPO 135)

6.3 Location

To obtain optimal operation of the unit act as follows:
A) Place the unit in a well ventilated room, far from heat sources.
B) Limit the number of door openings.
C) Make sure that the unit has good air supply and discharge.
D) Fit a drain line to the defrost water drain connection in the lower part of the evaporator.
Solution 1
Solution 2

6.4 Free room

When installing the unit leave enough free room to allow opening, correct use and easy maintenance in safe
conditions.
6.5 Installation
Place the condensing unit on the floor.
Install the evaporator as follows:
A) Drill the holes in the ceiling keeping the necessary distance from the wall.
A B
357 337
390 427
427 427
Solution 3
C D
620 614
820 1034
820 1693
Installation in a
coldroom with
more than one unit
23