Amana W10577942B Guide D'utilisation page 9

9.
Adjust settings, if desired*
The display will show the default settings for the selected
cycle. To adjust a setting, touch its name – Wash Temp or Spin.
Adjusting settings will change the Estimated Time Remaining.
Tightly packing the load, unbalanced loads, or excessive suds
may also cause the washer to increase the cycle time.
10.
Setting a delayed wash
If you do not want to begin a cycle immediately, you may
choose the DELAY WASH option. This will delay the start
of the wash cycle by up to 8 hours.
To set a delayed wash:
1. Touch DELAY WASH + and – buttons to set the desired
delay time.
2. Touch and hold HOLD TO START to set the delay. The delay
countdown has started when the HOLD TO START light
stops blinking.
11.
ouch and hold HOLD TO START
T
to begin wash cycle
Touch and hold HOLD TO START to start the wash cycle. To
pause a cycle in progress, touch HOLD TO START once, then
touch and hold again to continue the cycle. To cancel a cycle,
touch POWER.
Once you touch and hold HOLD TO START, you will hear the
door lock, unlock, and lock again. The washer door will remain
locked during the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2
missed garments, you may do so while the
"Add Garment" light is lit.
Touch HOLD TO START once; the door will
unlock once the washer movement has stopped.
This may take several minutes. Then close
door and touch and hold HOLD TO START
again to restart the cycle.
12.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has
completed to avoid odor and rusting of
metal objects on garments. When unloading
garments, pull back the door seal and check
for small items between the tub and the washer drum.
NOTES:
n A small amount of water may remain in the dispensers after
the wash cycle is complete. This is normal.
n This washer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer to dry
between uses.
* Not all options and settings are available with all cycles.
See "Cycle Guide" for available options and settings.
9