CONTROL PANEL AND FEATURES
Choosing the Right Detergent
Use only High Efficiency detergents. The package will be marked
"HE" or "High Efficiency." Low-water washing creates excessive
sudsing with a non-HE detergent. Using non-HE detergent
will likely result in longer cycle times and reduced rinsing
performance. It may also result in component failure and, over
time, buildup of mold or mildew. HE detergents are low-sudsing
and quick-dispersing to produce the right amount of suds for
the best performance. They hold soil in suspension so it is not
re-deposited onto clean clothes. Follow the manufacturer's
instructions to determine the amount of detergent to use.
Use only High Efficiency (HE) detergent.
Cycle Status Lights
Delay Wash
If a Delay Wash is set, the Delay Wash indicator will light and
the delay time will count down in the display.
Door Locked
Door Locked will light to indicate that the door is locked and
cannot be opened without first pausing or canceling the cycle.
Add Garment
When "Add Garment" is lit, you may pause the washer, open
the door, and add items.
Done
Once the cycle is complete, this light will come on. Remove
the load promptly for best results.
Efficiency Monitor
The Efficiency Monitor allows you to see how the settings
you select affect your energy savings. To use the Efficiency
Monitor, choose the best cycle, temperature, spin speed, and
options for the fabrics being washed. The Efficiency Monitor
will rate the water and energy use of those selections, from
Good to Best. You can then adjust the settings and options
to decrease the amount of energy used within that cycle.
USING THE DISPENSER DRAWER
1. Open the dispenser drawer.
2. Add laundry products as described in steps 4–6 in the "Using
Your Washer" section.
3. Slowly close the dispenser drawer. Make sure it is
completely closed.
NOTE: A small amount of water may remain in the dispensers
from the previous wash cycle. This is normal.
Adding HE detergent to dispenser
Selector
Pour a measured amount of HE
detergent into detergent compartment.
For powdered detergent, lift the selector
to the high position. For liquid detergent,
push down the selector to the low
position.
Do not overfill; adding too much
detergent may cause detergent to be
dispensed into the washer too early.
Selector
in high
position
Powdered detergent:
Lift the selector to the high
position.
IMPORTANT:
Do not add single-dose laundry packet to dispenser
n
drawer.
Use powdered detergent when using the Delay Wash
n
option. Liquid detergent may seep out before the wash
begins.
HE detergent
compartment
Use only High Efficiency
(HE) detergent.
Selector
in low
position
Liquid detergent:
Push down the selector to
the low position.
5