Hitachi VTP-16A Mode D'emploi page 6

English
IMPACT DRILL SAFETY WARNINGS
1. Wear ear protectors with impact drills.
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Before drilling into a wall, floor or ceiling, thoroughly
confirm that no items such as electric cables or
conduits are buried inside.
SPECIFICATIONS
Model
Voltage (by areas)*
Power input
Speed change
No load speed
Steel
Capacity
Concrete
Weight (without cord)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Chuck wrench ............................................................ 1
(2) Side handle ................................................................ 1
(3) Depth stopper ............................................................ 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Drill Bit for concrete
O.D
6.5mm
8.0
9.5
10.0
12.0
13.0
14.3
16.0
19.0
Optional accessories are subject to change without notice.
APPLICATIONS
By combined actions of ROTATION and IMPACT:
Boring holes in hard materials (concrete, marble,
granite, tiles, etc.)
By ROTATIONAL action:
Boring holes in metal, wood and plastic.
5
Length Code No.
100mm 931851
100 931852
120 931853
120 931854
160 971704
160 931855
160 931776
160 971670
160 931856
VTP-16A
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
1 2
-1
700 min 1400 min
16 mm 10 mm
35 mm 16 mm
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, inviting serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Fitting the drill bit
Fit the drill bit into the chuck and use the chuck
wrench to secure it, tightening the chuck by each
of the three holes in turn.
5. Selecting the appropriate drill bit
When boring concrete or stone
Use the drill bits specified in the Optional Accessories.
When boring metal or plastic
Use an ordinary metalworking drill bit.
When boring wood
Use an ordinary woodworking drill bit.
However, when drilling 6.5 mm or smaller holes, use
a metalworking drill bit.
6. High-speed/Low-speed changeover:
Prior to changing speed, ensure that the switch is in
the OFF position, and the drill has come to a complete
stop. To change speed, depress the shift Iock and
slide it in the appropriate direction, as indicated by
the arrow in Fig. 1. The numeral "1" engraved in the
drill body denotes low speed, the numeral "2" denotes
high speed.
7. IMPACT to ROTATION changeover: (Fig. 2)
The Impact Drill can be switched from IMPACT (impact
plus rotation) to ROTATION (rotation only) by simply
turning the change ring.
VTV-16
800 W*
1
-1 -1
0-700 min
16 mm
35 mm
3.8 kg
2
-1
0-1400 min
10 mm
16 mm