HWAM 3120 Mode D'emploi page 13

7. Remove the pre-cut plate (15) in the bottom plate of the stove by tapping on it with a soft hammer.
8. Attach the flexi-hose (16) to the connector bush and pull the insulation sleeve (17) onto the flexi-
hose.
9. Place the bottom of the heat shield between the stove and the guide pins (18) at the back of the
bottom plate on the stove and press it in towards the stove. Secure the heat shield with the 4 Allen
bolts (6).
10. Place the right side (5) on the guide pins on the bottom plate of the stove and press it in towards the
stove. Lift the side and press it lightly inwards until it engages behind the bolt (3) at the top. Secure
the bolt (3). Repeat with the left side. Finally secure the bolt (2) that holds the two sides together.
12. Replace the top plate (1) on top of the stove.
13