Leds; Led Status Related To An Error Message - Hexagon BPX 44 Mode D'emploi

9.2 Status of LEDs and output signals OUT on the BPX box used in stand-alone mode
LEDs indicate the operating status of the BPX box.
BPX44 in stand-alone mode
Stand-by
LED 8 Default l ON m OFF if the IN1 signal is activated
LED 4
m
LED 2
m
LED 1
m
M1: Not used
Status of the OUT signals in stand-alone mode
Stand-by
OUT 1
m
OUT 2
m
OUT 3
m
M1: Incoherent pulse (too short or too long)
M2: 1 (or more) probes out of range during set
to master or measuring.

9.3 LED status related to an error message

Both BPX box and TWIN Station have their own
status to indicate their operating status (and
error messages included). This status can be
Error message number
LED 8
LED 4
LED 2
LED 1
Error messages
E1 Power supply missing.
E3 BPX hardware problem.
E5 Corrupted probe memory (BPX).
E9 Fatal error, unexpected event.
E14 BPX or TWIN not initialized.
Set to
master to be done master done
m
k
k
Set to
master to be done master done
l
l
m
BPX44 in standard mode and TWIN Station
E1 E3
m m
m m
m k
k k
Set to Rework
l m
l m
l l
M2: Out of range, set to master failed
Set to Rework
l l
l m
l m
Stand-by means that the BPX is waiting
for a set to master or measuring command.
requested through the PC. In case of error, the
box is regarded as the «slave».
E5 E9 E14
m k k
k m k
m m k
k k m
E15 USB communication error, driver
not installed.
A9 BPX in stand-alone mode: the USB cable is
connected, but the power supply is missing.
A11 BPX is in stand-alone mode, the set to
master has to be done as described in
chapter 7.5.2
Good Scrap M1
m l m
l m l
m m l
Good Scrap M1
m m l
l m l
m l m
E15 A9
k l
k m
k m
k k
M2
l
l
m
M2
m
l
l
A11
k
m
k
k
15