Déclaration Fcc Et Ic - Sirona CEREC Mode D'emploi

2 Consignes de sécurité
2.2 Déclaration FCC et IC
8
2.2
Déclaration FCC et IC
Compliance statement
Fragment nicht übersetzen
This device complies with part 15 of the FCC Rules and to Industry
Canada's license-exempt RSSs.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exemts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionement.
Warning
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This in particular is applicable for the antenna which has been delivered
with the CEREC Radio Device.
RF Exposure
To comply with FCC RF exposure requirements for mobile transmitting
devices, this transmitter should only be used or installed at locations
where there is at least 20cm separation distance between the antenna
and all persons.
Information to the User
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada ICES-003: CAN ICES-3 (B)/
NMB-3(B).
Sirona Dental Systems GmbH
Notice d'utilisation Module radio CEREC
65 45 185 D3492
D3492.201.09.01.03 05.2015