Dometic GROUP WAECO PerfectView CAM60ADR Mode D'emploi page 32

Mounting the camera
If you would like to attach the camera with threaded screws fitted
through the construction (fig. a, page 6)
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell
when they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
Creating a through-hole for the camera connection cable
(fig. b, page 6)
I
NOTE
If possible, use available openings – such as ventilation grilles –
to feed the connection cables through. If there are no existing
openings, you must drill a hole with a 16 mm diameter.
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill
head to come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Mounting the camera
A
NOTICE! Risk of damage!
Only use the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Push the camera into the camera bracket.
➤ Attach the camera loosely with the two screws M3 x 8 mm in the slots
(fig. c, page 6).
32
PerfectView CAM60ADR
EN