Recommendations; General Information - Osburn 2500 Manuel D'installation

RECOMMENDATIONS

It is highly recommended that this appliance be installed and serviced by professionals who are
certified in the United States by NFI (National Fireplace Institute ) or in Canada by WETT (Wood
®
Energy Technology Transfer) or in Quebec by APC (Association des Professionnels du Chauffage).
If this appliance is not properly installed, combustible materials near it may overheat and
catch fire. To reduce the risk of fire, follow the installation instructions in this manual exactly. Contact
local building or fire officials about restrictions and installation inspection requirements in local area. It
is also recommended to inform your home insurance company.
It may be needed to get a building permit for the installation of this appliance and the venting system
that it is connected to.
Read this entire manual before installing this stove.

GENERAL INFORMATION

This stove does not work with a natural draft or without power source to activate the blowers
and the pellet feeding system. The stove will not work in the event of a power outage.
This stove has been developed and built to be used as a residential heater. Commercial or industrial
use is prohibited and will void the warranty.
The information given on the certification label affixed to the appliance always overrides the information
published, in any other media (owner's manual, catalogues, flyers, magazines or web sites).
Mixing of appliance components from different sources or modifying components is prohibited and
will void the warranty.
Any modification to the stove that has not been approved in writing by the testing authority is prohibited
and violates CSA B365 (Canada), and ANSI NFPA 211 (USA).
Stove Builder International inc. (SBI) grants no warranty, implied or stated, for the poor installation or
lack of maintenance of this appliance and assumes no responsibility of any consequential damages.
When locating this appliance, make sure the venting system will not interfere with any truss, roof
beams, wall studs, water pipes or electrical wiring. It may be easier to relocate the appliance than to
rework the building structure.
This stove is certified to comply with EPA NSPS 2015 particulate emission standards and is not
approved for sale after May 15 2020.
th
Page 2 Installation Manual - 2500