Silverline 951855 Mode D'emploi page 12

GB
Troubleshooting
Problem
Angle grinder does not start
when On/Off Trigger Switch (8) is
depressed
Cutting disc is off centre/vibrating
eccentrically
12
Possible cause
No power
Trigger Lock (9) not operated
Machine defective
Grinding/cutting disc is overly worn
Deformed grinding/cutting disc
Grinding/cutting disc not fitted correctly
Solution
Check mains connection
See 'Switching On/Off' section and Fig. I
Contact your dealer or authorised service centre
Turn off the grinder, remove and replace the disc
Turn off the grinder, remove and replace the disc
Turn off the grinder and refit the disc