Troubleshooting - AEG LA 10 Notice D'utilisation

4.7 Troubleshooting

Error / Malfunction
The compressor is switched on
but not functioning.
The storage battery is fully
charged and the fuse is good,
but the unit isn't functioning.
The compressor is overheated.
The compressor loses pressure
and does not build enough air
pressure.
The above table on troubleshooting and possible
causes and their repair does not indicate all
possible errors.
Possible causes
The operating switch
13
activated.
When switching on the operating
switch the LEDs and manometer
lighting do not light up. The
storage battery is empty.
The 15 A fuse is defective.
The unit is defective.
The compressor was operated for
more than 10 minutes.
The vents on the unit are covered
by an object or blocked.
The compressed air hose or
the compressor is leaking or
damaged.
The valve adapter or the
automotive valve connector is
not correctly attached.
If you are unable to resolve the malfunction with
the actions described, please consult a qualified
professional.
Solutions, repair
is not Activate the unit's operating
switch before using the
13
compressor.
Charge the storage battery using
the 230 V charging mains
adapter.
Replace the defective 15 A flat
fuse with a new fuse.
Please consult a qualified
professional.
Allow the unit to cool down for
10 minutes and follow the max.
operating cycle of 10 minutes of
operation and 10 minutes of cool
down.
Remove the object from the unit's
vents or clean the vents.
Please consult a qualified
professional.
Verify the valve adapter is
correctly attached to the automo-
tive valve connector and in the
item's valve. Verify the automo-
tive valve connector is correctly
seated on the tyre valve.
GB 25