Würth 0715 58 710 Traduction Des Instructions De Service D'origine page 18

3.6. Measuring DC current
1. Set the switch to
2. Place the clamp around the conductor to be
measured and release the trigger; check that
the clamp is correctly closed.
3. Read the measurement result on the display
unit.
For safety reasons, disconnect the measur-
ing leads before performing this operation.
The clamp must be positioned around a
single conductor in a circuit, with the risk of
rendering the measurement incorrect. The
best measurement is obtained with the
conductor centred in the middle of the jaws.
3.7. Measuring resistance
1. Set the switch to
2. Connect the red test lead to the
terminal and the black test lead to the
input terminal.
3. Apply the probe tips on the points where the
resistance is to be measured.
4. Read the result on the display unit
18
input