Publicité
Les langues disponibles
Les langues disponibles
more than 30 seconds, an alarm will light up and sound.
If the hoverboard leans forward or backward more than 35 degrees, the hoverboard
will be automatically switched off.
If a wheel is blocked for 2 seconds, the hoverboard will be automatically switched
off.
If the speed exceeds 10 km/h, an alarm will sound and the hoverboard will
automatically tilt towards the horizontal to decelerate.
If the speed accelerates intermittently, or if the hoverboard is used erratically, an
alarm will sound.
If the battery is about to run out of power, the hoverboard will enter self- protection
mode. Do not continue to use the hoverboard. Charge it fully to avoid damaging the
battery.
Calibration (reset)
Your hoverboard needs to be calibrated if you experience the following problems:
-Your hoverboard turn slightly to left or right when you ride straight ahead.
-Your hoverboard moves when it is in horizontal position where it should be still.
How to calibrate your hoverboard:
1.Make sure your hoverboard is horizontal. Press the on/off button until the light
flashes (approx. 10 seconds).
2.After 2-3 seconds the light will flash more slowly and you can now release the
on/off button.
3.Wait 3-4 seconds. Switch your hoverboard off and on again.
Your hoverboard is now calibrated.
DAILY MAINTENANCE
Regularly wipe the hoverboard with a soft cloth and detergent, if necessary. Brush
sands and dirt off the tires and wheels.
The hoverboard must not be washed or exposed to water, moisture or splashes.
Charge the hoverboard after use.
Charge the hoverboard fully before storage.
If you do not use the hoverboard for a long time, recharge it at least once every
three months to maintain the battery capacity.Store the hoverboard in dry and dust-
free place at room temperature.
Publicité
