Connecting The Video Recorder - Dometic GROUP WAECO PerfectView REC400 Instructions De Montage Et De Service

Connecting the video recorder

7 Connecting the video recorder
➤ Connect the GPS antenna to the "GPS" connection (fig. 2 1, page 3).
➤ Connect the 12 V/24 Vg connection cable to the "Power In" connection
(fig. 2 2, page 3).
➤ Connect the 12 V/24 Vg connection cable as follows:
– yellow cable to the battery
– blue cable to the positive terminal (terminal 15)
– black wire to earth
If there is no optical contact between the internal infrared receiver on the vid-
eo recorder and the remote control, you will need to connect the external in-
frared receiver:
➤ Connect the infrared receiver to the "IR" connection (fig. 2 3, page 3).
➤ If you are using the alarm function, you must connect the alarm cable to
the "Alarm In" connection (fig. 2 4, page 3) and to the signal generators.
If the camera connected features a mirror function, use the yellow cable of
the camera adapter cable for this. Depending on the camera model, the yel-
low cable must be connected to earth or be left unconnected for the mirror
function to be activated, or deactivated.
If the yellow cable is left unconnected, insulate the end of the cable with in-
sulating tape or a shrink sleeve to prevent malfunctions.
➤ Use the adapter cable to connect the cameras to the "CAM1" to "CAM4"
inputs (fig. 2, page 3).
If your monitor does not feature RCA output sockets for the video and audio
signal, you will require an adapter.
➤ Connect the audio/video cable to the A/V output "A/V Out" (fig. 2 9,
page 3) and to the monitor.
➤ Connect the microphone to the "MIC" connection (fig. 2 10, page 3).
34
PerfectView REC 400
EN