Installing The Video Recorder - Dometic GROUP WAECO PerfectView REC400 Instructions De Montage Et De Service

PerfectView REC 400
The following indicators and connections are found at the front of the video
recorder:
No. in
fig. 3, Designation
page 4
1 Green LED
2 Yellow LED
3 Red LED
4 Infrared receiver for remote control
5 Slot for SD card
6

Installing the video recorder

CAUTION!
A
 Install the device so that it cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause injuries to
the occupants of the vehicle.
 Never install the video recorder in areas where your head could
hit it, or in the path of an airbag. This could cause injury if the
airbag opens.
 Insulate all connections.
 Secure the cables against mechanical wear by using cable
binders or insulating tape, for example on existing cables.
The installation location should be level.
➤ Affix the video recorder to a suitable location in the vehicle (e.g. in the boot
or under the seat).
➤ Affix the video recorder using the four fastening holes.
EN
Installing the video recorder
Description
LED lights up: The video recorder is
switched on
LED does not light up: The video
recorder is switched off
LED lights up: GPS ready
LED does not light up: GPS not ready/
not connected
LED flashes: The video recorder is
recording
LED does not glow: The video recorder
is not recording
LED flashes quickly: The playback
mode is switched on
33