Actions On Alarms; Action To Switch Videos; Action To Reposition Telemetry; Changing The Actions - Videotec SM84A Manuel D'instructions

4.3 Actions o n alarms
For each alarm a pair of actions have been defined, to make alarm management more flexible:

action to switch videos

action to reposition telemetry.

4.3.1 Action to s witch videos
When there is an alarm event, the camera corresponding to the active alarm number is normally offered to all
monitors enabled for acknowledge: camera 1 corresponds to alarm 1, camera 2 to alarm 2 etc.
If it is necessary to switch a different video input from the standard, it is possible to request differentiated
switching using the action on alarm.
The screen for configuring each alarm shows a summary of the corresponding action:
[ALARM NO.1
[----------------------------]
[ 1.Type: Normally Open
[ 2.Reset: Cont
[ 3.Relay activation:
[ 4.Buzzer activation: NO
[ 5.Acknowledge: 1,2,3,4
[ 6.Action: CO4:MO2,R01:P03
[
[INC.Next Alarm
[DEC.Previous Alarm
[SEQ.End
4.3.2 Action to re position telemetry
If control of a telemetry line on the Aux line is provided, it is possible to reposition a pan & tilt or a dome on a
particular preset position in the event of an alarm:
[ALARM NO.1
[----------------------------]
[ 1.Type: Normally Open
[ 2.Reset: Cont
[ 3.Relay activation:
[ 4.Buzzer activation: NO
[ 5.Acknowledge: 1,2,3,4
[ 6.Action: CO4:MO2,R01:P03
[
[INC.Next Alarm
[DEC.Previous Alarm
[SEQ.End
4.3.3 Changing t he actions
From the alarm menu press
[ACTION ON ALARM 1
[----------------------------]
[ VIDEO
[ 1.Show Camera 4
[ 2.on Monitor 2
[
[ TELEMETRY
[ 3.On Receiver 1
[ 4.call Position 3
[
[CLEAR.Erase action
[SEQ.End
C04:M02 means that, in the event of alarm 1, camera 4 is
5]
switched to monitor 2.
The script C--:M-- means that the video switching action is
]
] not used and normal operation therefore is expected.
YES ]
]
]
]
]
]
]
]
R01:P03 means that, in the event of alarm 1, pan & tilt/dome
5]
number 1 is repositioned to preset position 3.
The script R--:P-- means that the telemetry repositioning
]
] action is not used.
YES ]
]
]
]
]
]
]
]
to enter the Action submenu.
Press
5.6]
item.
]
]
deletes the action settings.
]
During modification the item concerned flashes: press
]
]
/
]
]
insert the number directly when possible (e.g. press
]
]
insert the number 3).
]
Page 18
, , , to change the corresponding
to change the value and confirm with , or
to
MNVCSM84A_0408