Burg Wächter DG8500 Notice D'installation Et D'utilisation page 8

Preparation
IMPORTANT: Disconnect the system from the power supply to avoid serious
injuries, fire and material damage, electric shock, etc. Ensure that there
are no wires or water pipes in the wall where the device is to be installed.
Before installation, check that the system is voltage-free and protected
against unauthorised reconnection.
Work on electrical systems may only be carried out by qualified personnel.
It may be necessary to replace the existing doorbell transformer with
a suitable 8~20 Vac AC transformer.
1. Unscrew the retaining screws on the bottom
edge of the device by approx. 5mm using
the screwdriver and hexagon bit provided.
2. Insert the SD card (not included)
Insert the SD card in the into the slot
provided on the back of the device,
bottom left.
+ +
I I
3. Remove the existing doorbell button. The existing indoor chimes
will usually still function if the internal resistance is less than 5 ohms.
Installation
Note: Before installation check with your smartphone whether the WIFI
signal strength is sufficient. If necessary use a WIFI repeater to achieve
a better signal strength
1
2
5
3
4
1
Video door intercom module
2
Fixing screws 30 mm
3 Wire fixing screw
4 Wire with lugs
8 | English
Retaining screws
+ +
I I
7
6
8
Fig. Example installation
5
Base plate
6
Sun/rain cover
7 Anchors
8 Lever terminals
I I
1. Connect the lever terminals provided to the existing doorbell wire.
2. Hold the base plate in the desired installation position and mark
the holes to be drilled with a pencil.
3. Using a 6mm drill bit, drill a hole approximately 30mm deep
and insert the dowels provided.
4. Connect the wires supplied to the base plate
circuit board. Use the Phillips head bit
provided to loosen and tighten the screws.
The screws are inserted through the wires
lugs. Hand tighten the lugs.
5. For outdoor use we recommend that the
sun/rain cover provided is fitted. Place the base plate in the sun/rain
cover so that the holes are aligned.
6. Feed the wire through the slot provided below the circuit board
and the sun/rain cover if fitted.
7. Using the lever terminals connect the device wires with the existing
doorbell wires.
Existing doorbell
wires
8. Screw on the base plate (option: including the sun/rain cover)
hand-tight (2). The screw heads must sit in the depressions provided
for this purpose and must not protrude above them.
9. First hang the upper end of the eGuard on the two upper brackets of
the base plate. Then press the lower part level into the base plate.
Using light pressure push the housing down approx. 1.5mm until
the base
10. To secure the device gently tighten the retaining screws on the bottom
edge in a clockwise direction using the screwdriver and hexagon bit
provided.
Activation
1. Make sure that all cables and wires are undamaged and firmly
connected. Turn power button to position ON
2. Reconnect the doorbell transformer to the electrical supply (fuse).
The blue LED ring around the call button illuminates.
Wait until the system beeps to indicate that it is ready to be connected
Note: If the LED ring on the device does not illuminate, please read the
FAQ before proceeding with the next step of the activation procedure.
3. Continue with the installation of the TUYA app.
I I
I I
Unit wires
with lugs
DOOR EGUARD VIDEO BELL DG8500