Publicité
Les langues disponibles
Les langues disponibles
6. Insert one Wood Dowel (CC) into each of the
pre-drilled holes, then attach the Connect Block (I)
to the front panel, using Bolts (AA) and Washers
(BB) through the pre-drilled holes.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA
Bolt
BB
Washer
CC
Wood Dowel
7. MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO MOVE
COMPLETED UNIT INTO ITS FINAL POSITION.
To secure the completed Mantel to the wall tighten
screw (DD) through the Metal "L" Bracket into the
wall. It is recommended that you use wall anchors
when not screwing into wall studs.
Hardware Used
DD
Screw ø4*50mm
HH
Wall Anchor
8. PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO INSTALLING
ELECTRIC INSERT IN YOUR COMPLETED
FIREPLACE MANTEL. INSTALL THE INSERT IN
YOUR FIREPLACE CLOSE TO ITS FINAL
POSITION.
Lift insert carefully into the front of the unit and
center in the insert opening. Do not drag insert
across Hearth/Base (A) as it may scratch your unit.
Please refer to Section 4: "Mounting" in the Electric
Builders Box Installation Guide, provided with
Firebox - Model #'s 36EB110-GRT, 36EB111-GRC,
36EB220-GRT, 36EB221-GRC
Hardware Used
FF
Screw ø4*19mm
Fig. 6
I
x 4
x 4
x 4
Fig. 7
WALL
x 2
x 2
Fig. 8
Fireplace Insert
x 4
6
CC
BB
AA
HH
DD
EE
Electric
I
Install
Insert
From
Front
Publicité
