iwc 5005 Mode D'emploi page 23

Attaching the bracelet
Attach the component parts of the bracelet link to the
connection point, and push the pivot pin into the bracelet
from the side (1). Using the special tool provided, now
press the securing pin downwards (2) and, at the same
time, slide the pivot pin back into the bracelet until it lies
flush (3). The securing pin must be brought up flush with
the upper edge of the securing link. Please be sure to
check the correct seating of the pivot pin.
Effective from October 2007.
Technical specifications subject to change.
20 | 21