Resetting The Min/Max Values; Installation Location; Outdoor Sensor - BASETech WS-9130-IT Notice D'emploi

If the weather station is moved from one place to another, much higher or lower than the original
site (for example, from the ground floor to the upper floor of a house), remove the batteries and
place them again after about 30 seconds. This ensures that the weather station will not interpret
the relocation as a change of barometric pressure. You should still disregard the weather
forecast for the next 24 hours after relocating the weather station.
Weather tendency
The arrow-shaped weather trend display is to the left and right of the weather icons. The weather
trend display is closely related with the weather forecast icon.
If the arrow points up, the barometric pressure is increasing and an improvement of the weather
is to be expected.
If the arrow is pointing down, the barometric pressure is falling and the weather can be expected
to worsen.
f) Resetting the MIN/MAX values
All MIN/MAX values are reset at once.
In normal display mode, press and hold the MIN/MAX RESET button until a beep sounds. This
will reset the stored minimum and maximum readings.
The current measured values are saved as the new MIN/MAX values, until there is a change.

11. Installation location

a) Outdoor sensor
The included bracket can be used as both a wall bracket and base. Depending on the desired
installation location, it can be attached to the top, bottom and also the rear of the outdoor sensor.
The external sensor is designed for sheltered outdoor use. It should be placed so that it is not
subject to direct solar irradiation or rain/snow, because measured values may otherwise be
incorrect.
When installing the outdoor sensor, ensure that the battery compartment points down so that
no water may enter it.
39