Clatronic HMS 2772 Mode D'emploi & Garantie page 29

5....-05-HMS 2772
This is for switching to maximum speed for a short time. Press at short intervals for
pulsed mode operation.
WARNING! Do not use this function for more than one minute!
How to use the Kneader hooks/beater
1. Turn the power level selector switch (3) to "0/OFF" and ensure that the mixer (1)
has been disconnected from the mains.
2. Press the end of the kneader hooks/beater into the corresponding mixer ope-
nings until the hooks click into place. While pressing, turn slightly in order to
facilitate the whole operation. Please note that the kneading hook with the cur-
ved washer on the shaft can only be inserted on the left-hand side of the mixer
when viewed from the bottom.
3. Insert the mains plug into a properly installed 230V/50 Hz safety power socket.
4. The handmixer (1) can be used at various speeds set with the speed regulator
(3).
5. In order to release the kneading hook/whisk turn the power level selector switch
to "0/OFF" and ensure that the mixer has been disconnected from the mains.
6. Press the button (2) to release the kneading hook/whisk. Remove the device by
turning it slightly.
Please select a flat non-slip surface for the mixer stand.
1. Place the hand mixer (1) on the upper section (5) of the mixer stand (8). Please
check whether this is fixed firmly in place.
2. Mount the hooks as described above in the section "How to use the Kneader
hooks/beater".
3. In order to place the mixing bowl (7) underneath, press the button (6) to unlock
the upper section of the mixer stand (5) and fold the mixer upwards.
4. Place the mixer bowl filled with the desired ingredients onto the revolving plate.
Now fold the mixer down again.
5. Insert the mains plug into a properly installed 230V/50 Hz safety power socket.
6. The handmixer (1) can be used at various speeds set with the speed regulator
(3).
7. The mixing bowl is driven by the movement of the mixing tools through the
ingredients.
8. When you would like to stop mixing, turn the power level selector switch to "0"
and unplug the device from the mains.
9. When you have finished press the button (6) again to unlock the upper section
of the mixer stand (5) and fold the mixer upwards.
10. Now the mixer bowl can be removed. Remove the hooks as described above in
the section "How to use the Kneader hooks/beater".
06.05.2003 9:25 Uhr
Turbo operation
How to use the Mixer stand
Seite 29
GB
29