Toolland TC 78073 Mode D'emploi page 6

TC 78073
INDUSTRIAL FAN HEATER
TC 78073
WARNING
Read this manual carefully before using the
machine for own safety.
SAFETY INSTRUCTIONS
When using the appliance, always observe
the enclosed safety instructions as well as the
additional safety instructions.

In order to avoid heating please do not
cover the heater during usage.

When using electrical appliance basic
precautions should always be followed
including below.

The fan heater is not suitable for in damp
weather, in bathrooms or in other wet or
damp environments.

Please note that the fan heater can
become very hot. Therefore it should be
placed at a safe distance from flammable
objects such as furniture, curtains, ...

Do not place the fan heater immediately
under a wall socket.

If the supply cord is damaged, it must be
replaced by manufacturer, its service
agent or similar qualified persons.

This appliance is not intended for use by
persons (including children) with reduced
physical sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible for
their safety.

Do not connect the fan heater using an
on/off timer or other equipment which
can automatically switch the device on.

The fan heater must not be placed in
rooms where flammable liquids or gases
are used or stored.

Heater cannot be used in bathrooms,
showers and near pools.

Make sure the heater is always under
surveillance and keep children and
animals away from it.
PACKAGING
•
When packing out you must check the
appliance for transport damages and
missing pieces. When you notice damage
you must contact your dealer.
www.toolland.eu
•
Do not throw away the packaging. You
could use it when storing the appliance or
when sending back the appliance for
repair.
•
WARNING: Please store the packaging
well. Plastic bags and other packaging
materials could be dangerous for children
and pets.
INSTRUCTIONS

The appliance must be placed on a steady
surface.

Before connecting the appliance to the
power supply please check if the
appliance is switched off.

Put the power supply cable into the
socket.

Put the switch in the preferred position:
Fan working
Fan working + Heating 1650W
Fan working + Heating 3000W

The appliance starts working when one of
the above positions is used.

The appliance does have a thermostat.
When the temperature has reached the
preferred temperature the heating
element will stop automatically. When the
temperature is going down the heating
element will be switched on again.
WARNING: After the heating element is
switched off automatically, the fan will still
blowing till the appliance has cooled down.
This means it will blow away the hot air and
you will get a possible cold feeling in your
room. To prevent this cold feeling you could
turn off the appliance.
•
When the appliance is switched off (with
supply cord in socket) the fan will keep
blowing till the appliance is cooled down.
•
Pull out the supply cord when you do not
use the appliance.
OVERHEATING PROTECTION
The appliance is provided with a overheating
protection. This protection will switch off the
Nederlands
6