Section 8. Troubleshooting; Troubleshooting Guide - Jandy EE-Ti Manuel D'installation Et D'utilisation

Page 26
Jandy Heat Pump Models EE-Ti Installation and Maintenance Manual

Section 8. Troubleshooting

8.1

Troubleshooting Guide

The following table provides symptoms and solutions for general troubleshouting problems for the heat pump.
SYMPTOM
Heat pump will not start, no control board display.
Heat pump will not start, control board display working.
Heat pump runs but does not heat.
Heat pump does not run and control board displays:
FAULT-
NO FLOW
Heat pump does not run and control board display shows:
FAULT-
HIGH REF PRESSURE
Heat pump does not run or short cycles and control board
display shows:
FAULT-
LOW REF PRESSURE
Heat pump leaking water.
Table 4. Heat Pump Troubleshouting Guide
Breaker or fuse may be tripped. Reset breaker or check fuse. If
heat pump still does not run, call for service.
Three-phase models only - The phases may be
reversed or there may be a loss of phase, call for service.
Heat pump may be in delay count down of 5 minutes. Make
sure control board thermostat is calling for heater to come on
(check setting on thermostat and temperature reading). Make
sure heat pump is not in cooling mode.
Verify cold air is blowing out the top of the heat pump. If the
heat pump has just been installed or if the pool water has been
allowed to cool significantly, it is necessary to run the heat
pump continually for 24-48 hours. If the heat pump has been in
operation for some time, increase the circulating pump time, or
switch the control board to Maintain Heat function. If heating a
spa, verify no air intake stand pipes are open. If heat pump still
does not heat, call for service.
Verify circulating pump is on and all necessary valves are in the
correct positions. Verify filter and skimmers are clean. Check
water level in pool. Temporarily turn off all fountains and water
falls that bypass the heat pump water inlet. If this does not
correct the problem, call for service.
Verify circulating pump is on and that there are no water flow
restrictions to the heat pump. Make sure all necessary valves
are open or in the proper positions to allow proper water flow
to the heat pump. Verify filter and skimmers are clean. Check
for water level in the pool. This condition may also appear if
the heat pump has not been operated for an extended period.
To clear the condition, cycle the heat pump, on and off, up to 3
times. If this does not correct the problem, call for service.
Check that fan is operating and air is coming out of the top of
the heat pump, while short cycling. If heat pump does not run at
all, call for service.
Possible heat exchanger or plumbing leak. Turn the heat
pump off, then turn circulating pump off for at least one hour
to see if the water leak stops. If the water leak stops, normal
condensation is occurring. If the water leak continues, after the
heat pump is shut off for at least one hour, call for service.
CORRECTIVE ACTION