Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
1) Set time
Set the time before turn the heater on.
Press "LOCK" on remote control, LED display shows the current room temperature.
WEEK: Press "Set" button once, "I/W" light is on, press
HOUR: Press "Set" button again, "II/H" light is on, press
MINUTE: Press "Set" button again, "Fan/M" light is on, press
Note: When the "Set" key is pressed, the numbers flash on the display for 5 seconds, you must operate at this
time, or the unit will return to standby mode.
2) General Use
1. Switch on the appliance by pressing the main ON/OFF button, the appliance starts in fan mode and "Fan/M"
light is on.
2. Press "MODE" button, the device will blow warm air and "I/W" and "Fan/M" lights are on.
3. Press again "MODE" button, the device will blow hot air and "II/H" and "Fan/M" lights are on.
4. Press "MODE" button third time, the device will blow cold air and "Fan/M" light is on.
Control panel and remote controlare operated in the same way.
3) 24H TIMER
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
The "TIMER" button on the control panel and the "24h" button on the remote control have the same function.
2. Press the "TIMER" button to set the timer. Continue pressing "TIMER" button to increase the hours from 00--
24, the indicator "TIMER" lights up.
Note: "00" means no timer, "TIMER" indicator is off.
4) THERMOSTAT (only by remote control)
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
2. To adjust temperature, press
3. When the air temperature drops 2 degree below the set temperature, the heater will start heating with
"I/W"(1000W).
4. When the air temperature drops 4 degree below the set temperature, the heater will start heating with "II/H"
(2000W).
5. When the air temperature is 1 degree more or equal to the set temperature, the heater will blow cold air.
5) WEEK TIMER (only by remote control)
1. Switch on the appliance in any mode (fan, 1000W heating or 2000W heating).
2.
WEEK: Press "W·Timer" button, "I/W" and "W-Timer" lights are on. "1" in display means "Monday".
1- ON/OFF: Main power button
2- 24H:
Setting timer from 1-24 hours
3- MODE: 3 modes - COLD, WARM, HOT
4- LOCK: Child-Lock function for heater
5- AUTO: Open Window Detection
6- Delay: Set the turn on/off time of heater
7- W.Timer: Set the timer of one week
8- + :
Increase
9- - :
Decrease
10- Set:
Set current time
The remote control uses Lithium battery CR2025 3V (not included).
Do not allow children to play with the remote control.
The battery must be removed from the remote control before it is discarded.
The battery must be disposed of safely.
"+"
"+"
-
o "
" , to set the desired temperature, from 10ºC to 49ºC.
11
-
o "
" to set the week from 1-7 (Monday-Sunday).
"+"
-
o "
" to set the Hour from 01--00 (24h).
"+"
-
o "
" to set the minutes from 00--59.
Publicité
