Ecler EDRIVE 600 Manuel Utilisateur page 9

Parameter Knobs
Three velocity sensitive parameter knobs are used to adjust parameters shown on the display.
Up to three parameters at a time are display ed on the screen. The parameter name is shown above the
parameter value in each of the three screen secti ons. The parameter knobs have a fixed association
with the screen sections; the rightmost parameter knob adjusts the rightmost parameter and so on.
Output Signal / Limiter Indication
Two LEDs are provided for each output channel. These show the signal
limiter threshold. The yellow LED will light when the signal
warning LED will light when the limiter threshold is reached.
Mute Buttons and Status LEDs
Each output has a mute button and associated mute status LED. Pressing the button toggles the
mute on and off.
Note: That the mute buttons do not function when the Secure mode is activated.
Secure Button (on the rear)
A momentary button is fitted behind the rear panel, between the output X LRs and the RS232
port. When activated, this will disable all the front panel controls so they
making the unit secure against tampering. When in secure mode, the indicators still operate normally.
Note: That the communications port is still active in secure mode.
is 6dB below the threshold and the red
cannot affect the signal path,
level relative to the
9