Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

Playback
Use the SOURCE button to choose the input source for the KMC4: Bluetooth, USB, AUX, AM, FM, and WX. Press the SUB/ZONE
button to change Subwoofer output volume; Hold the SUB/ZONE button to change the Zone2 output volume.
The KMC4 will automatically enter Bluetooth pairing mode when there is no Bluetooth connection, with the display message "In
Pairing Mode". Hold the FAVORITES button to manually disconnect from a paired device and re-enter pairing mode. When you begin
scanning for devices on your audio device, the KMC4 will identify as "Media Center".
Set favorite presets for your favorite AM, FM, and WX stations by selecting the station, pressing the FAVORITES button, selecting the
favorite number (1–10) you wish to set, and pressing and holding the VOLUME KNOB for 2 seconds.
The USB input source is only available when there is a USB device connected. The KMC4 will automatically switch to USB input when
a USB device is connected and detected. KICKER recommends SANDISK drives for the best performance. Drives must be formatted
in FAT32 fi le system. USB hubs are not compatible. High-bit rate fi les (320kbps) may experience errors. In testing, the KMC4 has been
shown to work with some HDD's and other fi le systems, however, this is not supported by KICKER!
Device Settings
Hold the MENU button to enter the device settings menu. Press the MENU button to enter the audio settings. The available settings
are: Loud, Area, Beep, Zone2, Z2VOL, HPF, and Dimmer. Use the VOLUME KNOB to change the available values for each setting.
LOUD - select On or Off for a low frequency boost
BEEP - select whether the KMC4 responds with beeps
Z2VOL - change behavior of Zone 2 volume control:
Relative: Zone 2 volume is locked to main volume.
HPF - hi-pass crossover: OFF, 50Hz, 80Hz, 120Hz
10
AREA - select North America or Europe
Zone 2 - toggles Zone 2 volume control on/off
Absolute: Zone 2 volume is adjusted independently of main volume
Dimmer - adjusts screen and button brightness: 1–10

Publicité

Table des Matières
loading

Table des Matières