Troubleshooting - Kicker KMC4 Manuel D'utilisation

Audio Settings
Press the MENU button to begin cycling through the audio settings menu. Press the MENU button to enter the audio settings. The
available audio settings are: Bass, Treble, Balance, Fader, and EQ. Use the VOLUME KNOB to change the available values for each
setting.
EQ - select between EQ presets: Flat, Classical, Pop, Rock, Off, and Custom
When Custom EQ is selected, press the MENU button to enter custom frequency adjustments for 60Hz, 250Hz, 500Hz, 1kHz, 3kHz,
and 8kHz.

TROUBLESHOOTING

If your KMC4 does not appear to be working, check the obvious things fi rst such as blown fuses, poor or incorrect wiring connections etc. If you're
using an amplifi er, check for incorrect setting of crossover switches and gain controls etc.
No Power?  Press the SOURCE/POWER button and make sure the KMC4 is turned on.  Check the +12V power wire, ground wire, and fuse(s)
for power and proper connection.
No or low output?  Check the balance control on the KMC4.  Check the speaker output connections.  Power cycle the KMC4. Check the
volume of the audio source.
Reduced volume? Reverse a speaker connection from positive to negative on the stereo channel(s); if the volume improves, the speaker was out of
phase.
Buttons/Device Unresponsive? Perform Factory reset.
Factory reset: Reset the KMC4 to factory default settings by pressing and holding the PLAY/PAUSE button for ten seconds.
Radio stations not being received?  Check volume of audio source.  Check the antenna for proper connection and ensure the AREA setting
in the menu is set to the correct region.
If you have more questions about the installation or operation of your new KICKER product, see the Authorized KICKER Dealer where you made your
11
purchase. Please E-mail support@kicker.com or call Technical Services (405) 624-8583 for unanswered or specifi c questions.