Operation - Kicker KMC2 Manuel D'utilisation

OPERATION

Playback
Use the SOURCE button to choose the input source for the KMC2: FM, AM, Bluetooth, USB, or AUX.
When Bluetooth is selected as the input source, the KMC2 will automatically enter Bluetooth pairing mode if there is no previous
Bluetooth connection, identifying as "KMC KICKER" to your audio device. You may also select "BT PAIR" from the menu to enter pairing
mode. While in pairing mode, the Bluetooth icon will flash. When successfully paired, the Bluetooth icon will become solid.
The USB input source is only available when there is a USB device connected. The KMC2 will automatically switch to USB input when
a USB device is connected and detected, with a USB icon. KICKER recommends SANDISK drives for the best performance. In testing,
the KMC2 has been shown to work with some HDD's, however, this is not supported by KICKER! Drives must be formatted in FAT16
or FAT32 file systems. When in USB playback mode, you can access the RANDOM and REPEAT playback settings by pressing and
holding the PRESETS button.
To save a preset, tune to the radio station you'd like to save, then hold the PRESETS button to enter the saving presets menu. Scroll
to the preset number you'd like assigned to that station, then press the knob. You may save 12 AM presets and 18 FM presets.
Device Settings
Press and hold the MENU button to enter the Device Settings menu. The available settings are: PAIR, BEEP, LOUD, REG. Use the
VOLUME KNOB to change the available values for each setting, then press it to confirm the settings. LOUD setting will be applied to
the RCA outputs.
BT PAIR - select Bluetooth input source and enter pairing mode
LOUD - select On or Off for a low frequency boost
9
BEEP - select whether the KMC2 responds with beeps
REG - select USA or EUR for tuner region
FM tuner increments of 200kHz (USA) and 100kHz (EUR)
AM tuner increments of 10kHz (USA) and 9kHz (EUR)