Bosch PTK 3,6 LI Mode D'emploi page 28

OBJ_BUCH-1433-002.book Page 28 Friday, March 16, 2012 9:10 AM
28 | English
Operation
Starting Operation
Switching On and Off
– At first, firmly place the tacker head 1 against the workpiece until it is
pushed in a few millimeters. Afterwards, briefly press the trigger 5
and then release again.
The trigger lock, which is connected with the movable tacker head 1, pre-
vents unintentional shot actuation when the trigger 5 is inadvertently
pressed.
Working Advice
This machine is not suitable for working with 19 mm staples.
Therefore, do not use the machine to fasten ceiling panelling with
profiled wood or grooves.
When the staple is jammed in the machine, do not hold the ma-
chine by the trigger. When removing a jammed staple, the trigger can
be inadvertently actuated.
Avoid blank shots in order to reduce the wear of the impact striker.
Carefully apply the tacker head 1 to the material being tacked. Soft work-
pieces (e. g. pinewood) can become damaged by applying too much pres-
sure.
Maintenance and Service
Maintenance and Cleaning
For safe and proper working, always keep the machine clean.
If the machine should fail despite the care taken in manufacturing and
testing procedures, repair should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order, please always include the
10-digit article number given on the type plate of the machine.
After-sales Service and Customer Assistance
Our after-sales service responds to your questions concerning mainte-
nance and repair of your product as well as spare parts. Exploded views
and information on spare parts can also be found under:
www.bosch-pt.com
1 619 929 L03 | (16.3.12) Bosch Power Tools