Aiwa LCX-107 Mode D'emploi page 7

Programmed Play
Up to 30 tracks can be programmed from the disc.
1 In stop mode, keep s pressed until "M" flashes
in the display.
2 Press f or g to select a track, then press
s to store it.
Track number Programmed number
To select a track with the remote control
Press the numbered buttons 0-9 and +10.
3 Repeat step 2 to program other tracks.
To return to stop mode in steps 1 to 3, keep s pressed.
4 Press c/a to start play.
To check the program, press f or g in stop mode.
To clear the program, press s once in stop mode so that
"M" disappears in the display.
To change the programmed tracks, clear the program
and repeat all the steps again.
LCX-107 (U) Eng 7
TAPE OPERATION
—Use Type I (normal) tapes only. —
Inserting a Tape
Press Z to open the cassette holder and insert
a tape with the exposed side down and the side to
be played facing out.
Push the cassette holder to close.
Playing a Tape
Press c while the power is off.
The power is turned on and play of the inserted tape begins.
The volume level is displayed during tape operation.
Z– Stops play. The power will be automatically turned
off.
a– Pauses play. To resume play, press again.
f, g- Fast forwards/rewinds. To stop winding, press
Z.
About cassette tapes
•120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
•Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may jam in the mechanism.
Recording
Note that recording is done on only one side of the tape.
1 Insert a tape with the side to be recorded facing
out.
2 Get ready to record from the source.
To record from a CD, press CD and load the disc.
To record from a radio broadcast, press TUNER/BAND
and tune to a station.
To record from the connected equipment, press AUX
and start playback.
3 Press w to start recording.
c is pressed simultaneously.
When the selected function is CD, CD play and recording
starts simultaneously.
To record only the selected tracks of a CD
1 Follow steps 1 to 3 of "Programmed Play" to program tracks.
2 Press w.
To stop recording, press Z. To stop CD play, press
s.
To pause recording, press a. To resume recording, press
again.
To erase recording, press w while the power is off.
After recording, press POWER6STANDBY to turn the power off.
11/21/00, 10:26 AM
En
7