Tivoli Audio Music System+ Manuel Utilisateur page 7

Masquer les pouces Voir aussi pour Music System+:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
4. CLOCK: Press and hold to set. A beep will confirm you are in the clock set mode. Use the
volume knob to select the hour (Figure 6) and then press the volume knob in to set and cycle to
the minutes (Figure 7). Adjusting the hour does not affect the minutes and vise-versa. Repeat
this process to set the year, month and the day (Figure 8, 9 and 10). Once set, press the Clock
button briefly to recall the date and time whenever DAB, RDS or CD Text is displayed. When
the date is shown, only the month and day will show (not the year).
Fig 6, 7, 8, 9, 10
5. PRESETS 1–6: Press and hold to memorize the tuned station to that particular preset. A beep
will sound confirming the station has been successfully stored. Press briefly to recall the station
associated with that preset. There are 6 DAB presets and 6 FM presets. If a Preset button is
pressed but no station has been set, the display will show "Preset Empty" for 2 seconds. These
buttons will also act as limited direct track access during CD playback. The same station
cannot be saved to more than 1 preset. Note the remote control's 1 through 6 buttons cannot
be used to save favorite stations to the presets, only recall them after they have been saved
using the Music System+'s front panel buttons.
6. SOURCE/BT: Briefly press to cycle through the sources: DAB, FM, CD, Bluetooth/Auxiliary. The
source can't be changed while the alarm is sounding. If the source is changed during CD playback
and the source is changed back to CD again, the CD will start playback from the first track.
SLEEP: With the Music System+ playing DAB, FM, CD, Bluetooth or an auxiliary device, briefly
7.
press to begin the 20 minute Sleep timer. The corresponding green LED will illuminate while the
Sleep timer is active and the display will countdown the remaining Sleep time. The Music System+
will power off automatically at the end of the Sleep cycle. Sleep cannot be activated in CD mode
unless a CD is loaded. Note DAB, RDS and CD Text will not be displayed in Sleep mode.
/ TUNE
8.
track if the track has been playing for under 10 seconds. If the track has been playing for more
than 10 seconds, pressing the
buttons during shuffle play may cause tracks to repeat. When listening to FM, press briefly to
change the frequency up or down. In FM mode, press, hold, and release to seek for the next
strongly received station. Press and hold to quickly advance through the frequencies.
In DAB mode, press to access and navigate the DAB Station List. The volume knob may also
be used to navigate when in the Station List. Press the volume knob in to tune a DAB station
or press the "Enter" button on the remote. The Music System+ will return to the last-tuned
station if no action is taken in the Station List after 3 seconds. Note the volume knob will not
control the volume level when in the DAB Station List.
9. STOP: Press to stop CD playback and return to the first track.
+
– :
/
Briefly press to advance to the next track on a disc or back to a previous
button will re-start the currently playing track. Using these
7 – ENGLISH

Publicité

Table des Matières
loading

Table des Matières