Aair Line Fittings; Bconnecting To The Air Source - Cassese MACH 45 UNI Mode D'emploi

USER MANUAL
When levelling the machine, if the machine is installed against a working table, make sure a long frame will
not be ris en up by the table , because this would cause bad joining. Working table and machine should be
levelled together.
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
should be installed in a dry environment providing temperate temperature. The floor should be flat and
clean. Select a location with proper lighting.
2.A AIR LINE FITTINGS
Quick
release(Q/R)
Female
Air Connector
- Z749
2.B CONNECTING TO THE AIR SOURCE
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
Connect the machine
using the quick
connectors as
mentioned in
chapter I.2.A
Included in the machine
Standard hose connector - Z556
Q/R US male connector - Z701
Figure 2-15
The MACH 45 UNI
must be connected
to the air source
located on the front
panel of the drawer.
Turn the compressed
air valve to ON by
rotating its red knob .
The air pressure
gauge should show 6
bars (85 p.s.i.)
minimum.
MACH 45 UNI
Figure 2-16
13