Publicité
Les langues disponibles
Les langues disponibles
WARNING: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face and
body.
• Always wear eye protection.
• Be sure bonnet is snugly installed on pad.
• Keep hands and fingers away from rotating bonnet.
• Before turning the switch to the ON position, be sure the pad is free to revolve harmlessly.
• Inspect the bonnet frequently for wear, dirt or imbedded debris.
CAUTION: Do not allow the power cord to contact the rotating bonnet as it may become
quickly tangled around it. If this occurs, turn tool OFF and unplug the power cord before
attempting to untangle the cord. If the cord is damaged, have it repaired or replaced at your
local tool repair station.
• Never use a damaged or torn bonnet.
• Wear proper clothing, short sleeves, nothing loose or bulky, such as shop coat, etc.
• Do not turn tool on unless the polishing bonnet is against surface being polished.
• Be extremely careful when polishing around sharp or protruding objects on the car body.
• This product is designed as a polisher only. Do not use as a sander.
CAUTION: Do not use abrasive or rubbing compounds. The abrasive nature of
these products can damage painted surfaces.
CAUTION: Wear appropriate hearing protection during use. Under some conditions and
duration of use, noise from this product may contribute to hearing loss.
SyMBOLS
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ........................ minutes
...................... direct current
.......................... Class II Construction
.......................... safety alert symbol
1
B
A
Descriptions figure 1
A. Pad
B. Front handle
C. On/Off switch
SAvE THESE INSTRUCTIONS
A ......................... amperes
W ........................ watts
.......................alternating
n o ....................... no load speed
........................ earthing terminal
.../min ..................revolutions or
reciprocations per minute
C
D
E
D. End handle
E. Foam applicator bonnet
F. Polishing Bonnet
4
current
F
Publicité
