ZTE MF288 Additif Au Guide D'utilisation page 36

IC
This radio transmitter (identify the device by certification number, or model number if Category II)
has been approved by Industry Canada to operate with the antenna types listed below with the
maximum permissible gain and required antenna impedance for each antenna type indicated.
Antenna types not included in this list, having a gain greater than the maximum gain indicated for
that type，are strictly prohibited for use with this device.
Immediately following the above notice, the manufacturer shall provide a list of all antenna types
approved for use with the transmitter, indicating the maximum permission antenna gain（in dBi）
and required impedance for each.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
IC : 5200E-MF288
IC Radiation Exposure Statement
This device complies with IC radiation exposure limits set forth for an uncontrolled environment.
In order to avoid the possibility of exceeding the IC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
Troubleshooting
Internet Related Problems
Problem
The device cannot access the Internet at all.
The download or upload speeds are very slow.
Failing to visit the WebUI configuration page
Failing to establish a connection between your device
and a client through Wi-Fi
18 Confidential and Proprietary Information of ZTE CORPORATION
Recommended Action

Please check your configuration settings.

Please wait 1~ 2 minutes for the device to
initialize.

Check your service indicator LED's.
The speed is dependent on signal strength. Check
your signal strength and network type.

Enter the correct address. The default address is
http://192.168.0.1 or http://setup.zte.

Only use one network adapter in your PC.

Do not use any proxy server.

Make sure the Wi-Fi function is active.

Refresh network list and select the correct SSID.

Check the IP address to make sure your client
can obtain an IP address automatically in the
ZTE MF288 User Guide